UK perspective. Global industry.
AboutAdvertiseReading list
THEAUTOMOBILEDAILY

The business of mobility.
The decisions that move it.

Home›Coverage
Commercial & FleetExplainer

Electric van range: payload, temperature and speed in real work

WLTP tests vans part-loaded on a short laboratory cycle. Adjust the published range for payload, body, season, speed and auxiliary loads using your own route data, then set the reserve as fleet policy.

Email story
Unbranded white panel van driving along a rural road, with motion blur behind
Illustrative photograph · Jan Kopřiva / Unsplash

Electric van range on a specification sheet is a laboratory result, and a working van rarely drives the laboratory day. Payload, body conversions, cold mornings, motorway legs and the equipment running in the back all draw on the same battery, so the figure a fleet can rely on is usually lower than the headline.

This explainer sets out what the official test measures, how each real-world factor moves the result, and how UK fleet managers can turn a published figure into a planning range with a buffer that protects the last job of the shift. It draws on the test regulation, manufacturer statements and published fleet data.

What the WLTP electric van range figure measures

New vans sold in Great Britain carry range and energy figures from the Worldwide Harmonised Light Vehicles Test Procedure (WLTP). The Vehicle Certification Agency explains that the figures are obtained in a laboratory under specific test conditions, and that driving style, accessories and extra weight carried all change what drivers achieve.

For the faster vehicle class, the WLTP cycle lasts 1,800 seconds, covers about 23.3 km and reaches a top speed of 131.3 km/h across low, medium, high and extra-high phases, according to the cycle summary published by DieselNet. That is a short, mixed drive on a rolling road, not a day of stop-start deliveries or a long motorway run.

The test also uses a defined mass. Under Annex XXI of Regulation (EU) 2017/1151, as retained in UK law, the test mass is the vehicle’s actual mass plus 25 kg plus a representative load. For category N vehicles, which include vans, that representative load is 28 percent of the maximum vehicle load; for passenger cars it is 15 percent. Factory optional equipment is counted in the actual mass. A van tested this way is therefore partly loaded, not empty and not at its gross weight.

Payload and body conversions

A van running near its payload limit carries far more than the test assumes. Geotab notes that heavier vehicles need more energy to move and that cargo affects range, with the effect most visible on hilly routes. The scale of the effect depends on the route: weight costs most where the van accelerates and climbs often, and some of that energy returns through regenerative braking on the way down.

Battery choice and payload also trade against each other. Ford lists the E-Transit with a maximum payload of 1,586 kg for the standard range battery and 1,362 kg for the enhanced range battery, so the larger pack that adds range also takes payload away.

Conversions add a further layer. Racking, a box body, a tail lift or a refrigeration unit adds mass, and a taller or squarer body adds aerodynamic drag. A fitted body from a converter may not be reflected in the base vehicle’s published figure, so ask the converter and the manufacturer what range evidence exists for the completed vehicle. Our guide to specifying the electric van around its working body covers that brief in more detail.

Temperature, heating and auxiliary loads

Temperature is the factor fleets notice first. In an analysis of 4,200 connected battery electric vehicles and 5.2 million trips, published on 30 October 2025, Geotab found that vehicles averaged about 115 percent of rated range around 21.5°C, stayed at or above rated range between roughly 10°C and 31°C, and fell to about 54 percent of rated range at minus 15°C. The data covered cars and other vehicles and did not separate out vans, so treat it as a guide to the shape of the curve.

Much of the cold-weather loss comes from heating people rather than moving the van. Geotab puts cabin heating at 3,000 to 5,000 watts against about 75 watts for a heated seat or steering wheel. The US government’s fueleconomy.gov, citing 2019 AAA testing, reports range down about 41 percent in cold weather with the heater in use, but only about 12 percent at 20°F (about minus 7°C) with the cabin heater off. Doors opening at every drop make the cabin harder to keep warm.

Auxiliary equipment draws on the same battery. Mercedes-Benz says eSprinter range depends on factors including weather, load, use of air conditioning and heating, other electrical systems and vehicle configuration, particularly top speed. For a refrigerated van, inverter-powered tools or a lighting rig, measure the auxiliary draw on a working day rather than assuming it.

Pre-conditioning the cabin while the van is still plugged in can extend range, according to fueleconomy.gov, because the energy comes from the grid rather than the battery. Our article on winter range and the departure routine sets out how to build that into the start of a shift.

Speed and route

Speed matters more for vans than for most cars because of their large frontal area. Geotab lists high-speed driving among the habits that reduce efficiency. Mercedes-Benz names top speed configuration as a range factor for the eSprinter, and Ford says the E-Transit Eco Mode limits top speed, acceleration and the power drawn for climate control to make the remaining charge go further.

The practical point is that two vans with the same specification can return very different results. A multi-drop round at urban speeds sits closer to the conditions in which electric drivetrains are efficient, while a regional run with long dual carriageway or motorway sections will use more energy per mile. Route data needs context before it guides procurement, and averages across a whole fleet can hide the routes that matter.

Planning electric van range with a buffer

A defensible planning figure starts with the published WLTP range and adjusts it for the work, not the other way round. The table summarises the main factors and where to find evidence.

Factor Direction against WLTP Evidence to use
Payload above the test load Lower, most on hilly or stop-start routes Weighbridge or axle-load data and telematics energy use
Body conversion Lower through mass and drag Converter and manufacturer data for the completed vehicle
Cold weather and cabin heat Lower, sharply below about 10°C Seasonal kWh per mile from your own vans
Motorway speed Lower Route-level energy use by road type
Auxiliary equipment Lower Measured draw on a working day
Mild weather and urban driving Can match or exceed rated range Summer telematics on the same routes

A workable method is to record energy use per mile by route and month during a pilot, take the worst realistic month for each route type, then add a reserve that the business sets as policy, so drivers are not left judging it at the roadside. For example, a regional parcel fleet might plan winter routes on its own January data with a reserve big enough to reach a public charger, and leave summer planning on the milder figure. Recording loads alongside energy use, as discussed in our guide to payload management, shows whether a shortfall comes from weight, weather or the route.

Key points for fleet managers

  • WLTP electric van range comes from a 30-minute laboratory cycle with vans carrying 28 percent of their maximum load.
  • Payload, body conversions, cold weather, motorway speed and auxiliary equipment all reduce range against the published figure.
  • Published fleet data shows range near or above rated in mild weather and around half of rated at minus 15°C.
  • Cabin heating is a large share of winter loss; pre-conditioning on charge and heated seats help.
  • Plan from your own seasonal energy data per route and set the reserve as a policy figure.

Sources

Sources checked in November 2026. Rules, rates and schemes can change after publication, so check the linked official pages before acting.

Email story
NEXT

Follow the story

All coverage